Insert the screwdriver at the bottom to lift the rollers from the track.
Take sliding door off track.
If your sliding glass doors don t have the screen door then you may move on to the next step.
Start with the removal of the screen door.
Look at the bottom of each closet door to locate wheels that rest on the bottom track.
To remove the screen door use a flathead screwdriver.
Taking the door out of the track 1.
Work the door slowly into the opening in this manner.
Once the door is approximately under the hole in the track release the pivot.
2 pull out the rollers and the weatherstripping gasket.
How to repair sliding door rollers 1 unscrew the rollers from the bottom edge of the door.
According to this old house debris build up is the main reason for a sliding door that refuses to glide.
3 remove the rollers.
Here s how you can clean the rollers and the track.
Even if you have brackets on the bottom of your door they re probably just connected to your wheels.
Pushing the wheels up will make it easier to.
In order to remove the sliding one effectively lift it upwards into the upper track and ask a helper to push the bottom gently and carefully toward you.
Loosen every single screw to ensure that you don t miss one and crack your.
Note that the rollers of the door shown here reside up inside a.
Pull the door up from the bottom track until the wheels are out.
Sliding patio doors have two separate units namely the sliding door panel and the stationary panel.
Hold down the spring loaded guide on the opposite side of the other door panel and swing the door until the guide is under the track.
Wiggle the door until the pivot snaps into the hole.
Bring the door to within a few inches of the strike side jamb.
Keep lowering the panel until it is completely out of the upper track and free.
Loosen the screws at the top of both doors.
Try holding your foot against the bottom of the door and pull gently on the top of the door to lift the back side.
Open the door and ask your helper to slightly lift the screen door.
Once secure release the door.
Slide the door over.
Find the adjustment screw and rotate it with a screwdriver phillips or slotted depending on model to bring.
Slip a flat screwdriver underneath the wheels and push them upwards.
Dirt mud hair and fur can collect along the track and in the groove which clogs the rollers underneath and prevents smooth motion.
You will be able to tell the wheels are sufficiently.
Remove the door from the track.