Sunsetter Awning Led Lights Not Working

Press and hold my for 8 seconds the light should blink the entire time.

Sunsetter awning led lights not working.

As you continue to hold the down button the led lights will dim down to fully off. Sunsetter recommends channel 1 be used to operate your awning and channel 2 be used to operate your led light system unless you did not purchase a motorized awning then use channel 1 to operate your led light system. When a desired dimming level has been achieved release the down button. Sunsetter recommends channel 1 be used to operate your awning and channel 2 be used to operate your led light system unless you did not purchase a motorized awning then use channel 1 to operate your led light system.

Unplug the motor and plug it back in. If it does continue to the next step. Control box the first time the led light system is plugged in. Plug in the power cord and close the awning the rest of the way.

Check power at the quick connect outlet or power source. Flip it off and back on and then recheck the test panel. You get a set of lights for each arm plus a waterproof transformer box that converts 110 volt to 12 volt to save energy. If still not working you ll need to locate the power converter and make sure it s plugged into it s outlet.

If there is power present continue to the next step. The awning s settings and electricity supply are also common sources of trouble. How to use the multi channel remote transmitter see figures 13 14. How to use the multi channel remote transmitter see figures 13 14.

Not available for the 1000xt model awning. The set is cream colored to match your awning s hardware perfectly. Step 1 push the middle button on the remote control and unplug the awning s power cord from the electrical outlet. Press the neutral middle button on the transmitter.

Unplug the power cord from the wall. Be sure to order dimming led lights for your sunsetter awning. The awning s motor or remote control is usually to blame when the unit stops working as you expect. There s a dedicated circuit breaker for the power converter.

Verify that the red light on the remote transmitter comes on when you press and hold the button. You should always troubleshoot your awning before calling the manufacturer to see if you can solve the problem yourself. The reset process appears convoluted but when followed closely it will reconnect the remote control with the motor control unit. On many rigs it s located behind the rear wall of the pass through basement storage.

If the remote control stops working with the awning it needs to be reset. T z z á z u o u µ o o ç v z o µ o z á v v p o v p x. If not replace the cr2430 battery. Dimming the led strip off when the led light strip is fully on press and hold for more than second the down button on the remote transmitter.